TC2050-IDC-NL-M – Tag-Connect No-legs 2050 to Male IDC
$45.00
10-Pin “No-Legs” Plug-of-Nails™ Cable with Male Ribbon connector – only for use where existing cable can’t be removed.
AVAILABLE
Description
Tag-Connect’s TC2050-IDC-NL-M “No-Legs” Plug-of-Nails™ programming cable is a 10-conductor cable fitted with a spring-pin Tag-Connector that conveniently plugs directly into your PCB and terminates in a 0.1″ male ribbon connector. These special male IDC cables are only for use where the existing debugger cable can’t be removed and has to be extended instead such as on some Altera USB Blasters and ByteBlasters.
- Plugs straight to your PCB – No mating connector or header required!
- Requires only a 0.03″ footprint of pads and locating holes in your PCB.
- Zero Cost Per Board!
- Tiny Footprint!
- High-Reliability Spring-Pins make a Secure Connection and are rated for over 100,000 operations.
- Footprint has no height and can reduce the size and space requirements of your PCB.
- A great way to make test and debug signals available at no cost and with minimal board space.
- Can be retained in place using a TC2050-CLIP board.
Tag-Connect cables provide a simple, reliable means of connecting Debuggers and Programmers or other test equipment to your PCB’s while lowering board costs and facilitating efficient production programming. Tag-Connect uses a specially designed (Patent Pending) connector which eliminates the need for putting a programming header or other mating connector on every PCB. Instead, Tag-Connect uses tried and tested spring-pins rated for over 100,000 operations to make a secure connection to a special footprint pattern of pads and locating holes in your PCB.
The tiny “No Legs” footprint takes only 0.03 square inches (about the same board space as a couple of SMT resistors) which means you can locate the footprint right next to the MCU if desired.
This 10-conductor cable has a TC2050-NL Tag-Connector on one end and a male 0.1″ ribbon connector on the other and is suitable for use with many MCUs / FPGAs and JTAG programming and debug operations where the existing cable can’t be removed from the programmer and has to be extended instead.
Also available in self-retaining “legged” version TC2050-IDC-M.
Datasheet (for TC2050-NL connector and footprint details only)
This product is used in the following debugger/device solutions:
This product is used as part of the following solutions for particular debuggers, protocols and devices. Solutions may involve additional cables, adapters or retaining clips, as well as this product you are viewing now. Click on the solution links to see full solutions and installation instructions where applicable.
Intel/Altera USB Blaster for Intel (Altera) using Altera JTAG (10 pin target connector, using male IDC)
Intel/Altera Byte Blaster for Intel (Altera) using Altera JTAG (10 pin target connector, using male IDC)
